Victron MultiPlus 24/1600/40-16 230V VE.Bus Inverter

The MultiPlus 24/1600/40-16 (Victron Energy, pmp242160000) is an advanced device combination consisting of a powerful 24v 1300w sine wave inverter, an advanced 40a battery charger utilizing adaptive charging technology, and a 16a high speed AC transfer switch.

In the event of a mains fault or, if the shore power or on-board generator is interrupted, the multi’s inverter is automatically switched on and takes over the supply of the connected loads. The switching occurs so quickly (in less than 20 milliseconds) that uninterrupted operation of computers and other electronic equipment is guaranteed.

main features of the MultiPlus 24/1600/40-16

• Cont. Output power at 25°c: 1300w at non-linear load
• Power at non-linear load 1600W
• Victron Energy mpn: pmp242160000
• for 24v system voltage
• integrated 40a mains charger for your batteries
• integrated 16a mains transfer switch
• UPS operation possible, PowerAssist and PowerControl function
• Extensive accessories available
• Can be used in numerous applications, whether on land or mobile

Proven Reliability

The complete bridging additionally with a ring transformer topology has proven itself for years. The inverter is short-circuit proof and protected against overheating (whether caused by overload or ambient temperature)

PowerControl

The Multi Control remote control panel can be used to set the maximum mains or generator current to be drawn. The MultiPlus then takes into account other connected AC loads and uses only the current that is “left over” for charging. This prevents the generator or shore power connection from being overloaded

PowerAssist

Load peaks often only occur for a limited period of time. In such a case, the MultiPlus ensures that insufficient shore power or generator output is immediately compensated by energy from the battery. If the load is reduced, i.e. if consumers are switched off, the energy that is then sufficiently available again can be used to charge the batteries

High switch-on power

This is required for switching on loads with high inrush currents, such as voltage converters for LED lamps, halogen lamps or power tools

Search mode

When the search mode is set to ‘on’, the power consumption of the inverter is reduced by approximately 70% during no-load operation. In this mode, if the multi is operating in inverter mode, it will shut down at zero load or at only light load and a sensor will measure the current output current every 2 seconds. If the output current exceeds a set limit, the inverter resumes operation. If this is not the case, the device continues to dwell in the energy-saving search mode

programmable relay

In the default setting, the multifunction relay acts as an alarm relay i.e. it switches off the device in the event of faults (device becomes too hot, ripple voltage at the input too high, battery voltage too low)

Specification: click here

Warranty: 5 Years by Victron Energy